Cinegears CG-FC821 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol Cinegears CG-FC821. Cinegears CG-FC821 9 halaman. Wireless follow focus controller

Halaman Cetak

Setting Up the Controller

Controller

The controls have been designed for ease of use: They allow for preset

memory points, where you can save up to four, as well as two lock points

that will cause the controller to vibrate as you approach them. Choose from 16

different speed levels to control the transition speed of the presets, and 4 different

damping levels from ultraresponsive to ultra smooth. The controller has an accuracy

circuit built into it to ensure the lens stop precisely where you want it to, even after

repeated use.

Synchronization

Turn on the remote control power switch and plug in the motor. Once both are

on hold (SET) + (POWER) for 3 seconds. The motor light will stop blinking, and

the gear will shudder. This means that the controller and motor have been

successfully synchronized. (Note: This process is usually done before leaving

the factory.)

Automatic Calibration

1) Before installing the drive onto the lens, please make sure the wireless

remote controller and motor are powered on and connected. DO NOT turn the

wireless remote control dial, put the drive gear close to the lens ring and

tighten the screws.The controller can automatically locate the start and end points

of any lens. To calibrate your lens, hold the (SET) + (A) button on the remote

controller for 3 seconds.

Manual Calibration

Rotate the focus ring clockwise to the end; hold (SET) + (REC) + (POWER)

buttons together for 3 seconds. Rotate to the opposite end and press the three

buttons again

LED Marker Light

Press (POWER) quickly to toggle marker light ON or OFF.

Screen Brightness

To change screen brightness, press and hold (SPEED) + (A), (B), (C), or (D),

(SPEED) + (A) being the lowest brightness level, (SPEED) + (D) being the

highest brightness level.