Cinepro 4K6 MK-4 SE-Gold Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Cinepro 4K6 MK-4 SE-Gold. Cinepro 4K6 MK-4 SE-Gold 9 halaman. High resolution - extended dynamic six channel theater amplifier

Halaman Cetak
SPEAKER OUTPUT
HOOK THE APPROPRIATE SPEAKERS
TO THE SPEAKER OUTPUT JACKS.
IF DESIRED, ANY OF THE
THREE DUAL CHANNEL
GROUPS MAY BE USED
IN STEREO, OR MONO.
ONE THROUGH SIX
CHANNEL OPERATION
IS POSSIBLE.
NEVER CONNECT ANY TWO SPEAKER
OUTPUT JACKS TOGETHER!
ALWAYS USE GOOD QUALITY SPEAKER CABLES.
OUTPUT - SPEAKER - MULTI-CHANNEL MODE
Connect the speaker wires to the 5 way binding posts. The red post is positive, and the black is negative. Dual banana jacks
(optional) are recommended to make secure and convenient connections.
Connect wires by stripping approximately 3/4 inches of insulation from the end and twist the strands clockwise into a tight
pack. Loosen the plastic insulator counterclockwise to the end. Insert the bare copper wire into the hole in the metal shaft, then
tighten the plastic insulator securely. Hand tightening should be suffi cient.
Be certain no strands extend outside of each connector. Be sure to switch the input mode switch to DUAL (See page 4).
NEVER CONNECT SPEAKER OUTPUT POSTS TO EACH OTHER!
OUTPUT - SPEAKER - MONO/CENTER CHANNEL MODE (FOR EXAMPLE)
The inputs and outputs on the back panel are organized into three-two channel groups. Any of these groups can be
converted from two to one channel (bridged mono) operation.
CENTER CHANNEL GROUP - Connect the positive lead from your center channel speaker to the top RED post, and the
negative lead from your speaker to the bottom RED post on the channel's you wish to bridge. Switch the DUAL/MONO input
switch to MONO for this group. The front channel and/or rear channel group can also be connected in the same manner as the
center channel group, as well as utilizing all three groups, producing up to 3 separate bridged channels.
DO NOT USE THE NEGATIVE (BLACK) POSTS AT ALL IN THIS MODE.
NEVER CONNECT THE TWO RED OR BLACK POSTS TO EACH OTHER!
Minimum impedance of center channel (or any bridged speaker) is four ohms.
Use a good quality, heavy gauge speaker wire.
REMOTE POWER OPERATION - 12V TRIGGER
On the back panel, below the input terminals, is a 12 volt remote trigger jack. This is useful for having the Cinepro 4K6 MK-4
SE-Gold come on when the receiver or processor is turned on automatically. Some high end processors have a 12 volt remote
trigger output designed just for this purpose. Simply connect a cord from the trigger out on the processor to the remote in on the
Cinepro 4K6 MK-4 SE-Gold. The 12V trigger is not polarity sensitive and will operate with a 9-15V source.
For 12 volt remote power operation, LEAVE THE FRONT PANEL POWER SWITCH ON at all times. The unit will go on and
off with the rest of your system, via the rear panel 12 volt jack. When the unit is on standby, the front panel LED and dual fan
pack will turn off. The majority of the amplifi er is shut down and in standby. Unplug this remote power when normal operation
via front panel switch is desired.
+

MONO MODE

–
5
FRONT
CHANNEL
GROUP
CENTER/
SUR-EFX
CHANNEL
GROUP
REAR
CHANNEL
GROUP
POWER INLET
CONNECTOR