ARC ZBCMR-300 Manual - Halaman 9

Jelajahi secara online atau unduh pdf Manual untuk Penerima ARC ZBCMR-300. ARC ZBCMR-300 10 halaman. Zigbee dimmer module receiver

Halaman Cetak
ARC ZBCMR-300 Manual
Issue Date: 18/04/2022
Mode
Initial power ON before entering network, module
1
will enter join mode.
Network Successful Connection.
2
Minimum brightness setup successful.
Switch in-between Trailing & Leading Edge /
3
Filament LED bulb Mode.
Turning ON using: APP、Touchlink、external
4
switch, and join button (in network).
Turning OFF using: APP、Touchlink、external
5
switch, and join button (in network).
6
Already in network then power ON module again.
7
Remove from a network (touchlink、join、app).
Factory New:
1. At standby mode, press and hold button >= 6
seconds
8
2. release button then within 12 second press button
once
TouchLink Commissioning:
1. During data exchange
9
2. After data exchanged confirm
Dimming using:
10
APP、Touchlink、external switch
LED & OUTPUT INDICATION
8. LED & Output Indication
LED Indication
Green LED on module will flash every 5 seconds
Time out in 60 seconds
⚫ Factory pre-set in Trailing Edge.
Leading Edge: Green LED twice and Red LED 3 times.
Trailing Edge: Green LED twice and Red LED 4 times.
Filament LED bulb Mode: Green LED twice and Red LED 5 times.
Leading Edge: Red LED once.
Trailing Edge: Red LED twice.
Filament LED bulb Mode: Red LED 3 times.
Leading Edge: Amber LED → then ending in green LED.
Trailing Edge: Amber LED → Green LED → Amber LED → then ending in green LED.
Filament LED bulb Mode: Amber LED → Green LED → Amber LED → Green LED → then
ending in Red LED.
Green LED will light up approx. 2 seconds
Green LED will light up approx. 2 seconds
Amber LED → Green LED → Amber LED → ending in Green LED
1. Green LED quick flash for approx. 12 Seconds
2. Amber LED → Green LED → Amber LED → ending in Green LED
1. Green LED flash 0.5 seconds once
2. Amber LED → Green LED → Amber LED → Green LED → Amber LED → ending in Green
LED
No indication
9
Output Indication
No indication
ON→OFF→ON→OFF→ON (last status
is ON)
No indication
ON
OFF
No indication
ON→OFF→ON→OFF (last status is
OFF)
1. No indication
2.ON→OFF→ON→OFF (last status is
OFF)
1. No indication
2. ON→OFF→ON→OFF→ON (last
status is ON)
Output to the corresponding dim level