ARC WBT-912 Panduan Memulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Beralih ARC WBT-912. ARC WBT-912 5 halaman. Wireless 2 channel wall switch module

aring:

Pairing using LEARNING MODE:

1. First choose the desired receiver(s) that you wish to control.

2. Press the 'Learn' button once (LED will flash), this will now enter learning mode.

3. On the wall switch press the 'ON' button intended to be paired; the load will flash twice to

confirm that the remote control is now paired.

NOTE: Learning mode lasts for 12 seconds; if no signal is given to the receiver then it will

automatically exit learning mode without pairing the device.

To exit learning mode manually, simply press the 'Learn' button again.

！If, during learning mode the load does not flash to confirm, this means that the receiver's memory

is FULL and no further wall switch may be paired unless one of the existing wall switch is first

unpaired (see below).

nparing:

Removing single device:

1. With the receiver that you intent to un-pair press the 'Learn' button once (LED will flash), this

will now enter learning mode.

2. On the wall switch press the 'OFF' button intended to be unpaired; the load will flash twice to

confirm that the wall switch is now unpaired.

peration:

ON/OFF Function:

Press the 'ON' button on wall switch, the lights will gradually illuminate.

Press the 'OFF' button on wall switch, the light will gradually turn OFF.

Dimming Function:

1. Make sure the load (light) is switched ON.

2. On the wall switch press the ON button again, the loads will start to dim.

3. To stop at the desired brightness level, press the ON button again.

※ Dimming level dims in cycle, during the cycle if no signal is given『with 4 cycles it will stop at

100% brightness』.

！After setting a dim level using the wall switch the light is then switched OFF, the next time that

the light is switched back ON again the load (light) will return to the previous stipulated brightness.

NOTE:

1. Using in conjunction with another remote control.

When load is first switched ON from the wall switch module then switched off by a remote control.

In order from the wall switch module to switch ON the load you must switch OFF and then switch

Version 1.