Cino FuzzyScan A770BT Series Panduan Memulai Cepat - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pemindai Cino FuzzyScan A770BT Series. Cino FuzzyScan A770BT Series 17 halaman. Cordless scanner fuzzyscan family
Halaman Cetak
- 1. Getting Familiar with Your Fuzzyscan
- 2. Preparations before Using
- 3. Install the Battery
- 4. Charge the Battery
- 5. Decide Your Radio Link Mode
- 6. Use Fuzzyscan in PAIR Mode
- 7. Use Fuzzyscan in PICO Mode
- 8. Use Fuzzyscan in HID Mode
- 9. Use Fuzzyscan in SPP Mode
- 10. Presentation Scanning
- 11. Batch Scanning (Inventory Mode)
- 12. Host Interface Quick Set
- 13. System Commands
- 14. Option Codes
- 15. Status Indicator
Use FuzzyScan in HID Mode
Ensure the battery is fully charged. Power on the scanner within radio
coverage and ensure the status indicator of scanner gives alternative
red and green blinks (in "Uninstall" state). If the scanner is not in
uninstall state, please scan the "Uninstall" command first.
If your remote host is equipped with latest Bluetooth drivers, or it's an iOS
or Android device, you are recommended to use "HID Mode" for quick
paring. If necessary, you may use "HID Mode with Passkey" to establish
a more secure connection. If you frequently experienced the problem in
using HID mode, please try "HID Legacy Mode" instead.
HID Legacy Mode
Once you scan one of above commands, the link indicator of scanner will
give 3 blue blinks per 2 seconds during searching process. You have to
execute the Bluetooth Discovery procedure to find available Bluetooth
device, then select "F(L/A)xxxBT-xxxx".
If you use "HID Mode", please go to step 5.
If you use "HID Mode with Passkey", you will be requested to enter the
Passkey (PIN) on the remote host. Please enter the Passkey (PIN)
accordingly by scanning the "Option Code" (page 13), and then scan the
"FIN (Finish)" to end the Passkey entry, then go to step 5.
If you scan "HID Legacy Mode", the Passkey (PIN) may be requested.
Please enter "00000000" (default setting), you will see "Keyboard on
F(L/A)xxxBT-xxxx". Please double click this HID service to establish the
connection between scanner and remote host device.
The scanner will emit 4 beeps in ascending tone to indicate the
connection is established. At the same time, the link indicator of scanner
will give 1 blue blink per 2.5 seconds to indicate the scanner is in
radio-connected state.
Please note that if the scanner is not connected to the host device within
1 minute after scanning the above command, the scanner will go to sleep
automatically. You can just press the trigger to wake up the scanner to
continue the installation.
The installation procedure may vary depending on different remote
host devices, operating systems and the Bluetooth drivers. Please
consult your professional IT consultant to obtain necessary support.
For more detailed information, please visit CINO website.
Uninstall
HID Mode
6
HID Mode with Passkey