Cino Micro2 Series Panduan Memulai Cepat - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Printer Cino Micro2 Series. Cino Micro2 Series 13 halaman.

Halaman Cetak

Maintenance and Troubleshooting

Cleaning Instructions

Please refer to following procedures and figures to clean the printer.
1. Power off Micro2.
2. Open the Media Compartment Cover.
3. Remove the Media Roll.
Platen Roller
Areas
Print Head
Tear Bar
Platen Roller
Interior
Exterior
1. Never use sharp objects to clean the print head. This may result in
damage to the printer.
2. Let the print head cool to room temperature prior to cleaning,
protecting yourself from burns.
3. The tear bar has sharp edges. Please be careful when cleaning
the tear bar to avoid possible injury.
Troubleshooting
Please review the following information to solve the common problems that
you may encounter with Micro2. If the problems are not covered in this
section, please consult your supplier for technical support.
Problems
No power
Media does not feed
Poor print quality
Communication
Error
No print
Use the cleaning pen or a cotton swab moistened with isopropyl
alcohol to clean the surface of the print head from end to end.
Use the cleaning pen or a cotton swab moistened with isopropyl
alcohol to clean the tear bar.
Rotate the platen roller and clean the surface of the platen
roller with cleaning pen or a cotton swab thoroughly.
Blow the paper dust by using a can of compressed air or by
vacuuming. Ensure the paper sensor windows are free of dust.
Use soft cloth moistened with water to clean the exterior
of the printer.
Make sure the battery pack is installed properly.
Recharge the battery pack.
Ensure media cover is closed completely.
Remove the obstruction in paper path.
Clean print head.
Check and recharge the battery pack.
Check the quality of media.
Check if the media is loaded.
Check baud rate.
Replace cable to terminal.
Make sure the sensor and the media are set correctly.
Verify if the communication between the host system and
the printer is established correctly. Then replace the battery
pack.
Methods
Solutions
9
Print Head
Tear Bar