Accurate Technology ProScale Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur Accurate Technology ProScale. Accurate Technology ProScale 20 halaman. Flush mount readouts
Juga untuk Accurate Technology ProScale: Panduan Memulai Cepat (17 halaman)

Halaman Cetak

Command Format

The receiver uses a standard format for all configuration commands.

1. A single command letter.

parameter state to be viewed without modification. Upper case letters

allow the user to change the parameter configuration.

2. One or more characters are used when modifying configuration

parameters. They have no effect when parameters are viewed (lower

case command letters).

The following is a list of command letters and their meanings:

V – Firmware version ID. No parameters.

S – System ID. Used to configure the receiver to only accept signals

from ProScale-RF displays that have the same system ID. This

prevents signals from other ProScale-RF displays with different

system ID's within radio range from being received. The default is

O – Output mode.

content. See Output Modes on page 9 for more information. The

default is mode 3; position, units and display ID.

D – Configures the delimiting character that is used to separate fields

within a record. The default is a space.

E – Enables or disables the character echo when typing in data from

the terminal program. The default is ON.

M – Record Start Marker. Enables or disables the use of the new

record start (sentinel) character, which is an *. When enabled,

each new record received starts with an asterisk (*). The default is

OFF.

T – Record Terminator. Each record can be terminated with either a

carriage return or carriage return and line feed. The default is

carriage return and line feed (CR/LF)

B – Baud Rate. Sets the baud rate used to communicate with the

receiver. The default is 9600 bits per second.

See a list of command examples beginning on page 14.

Accurate Technology Inc.

Lower case letters allow the current

Formats the record text for the desired data

Page 9 of 20