Accurate Technology TWINSPIN REEL SR-30 L Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Memancing Accurate Technology TWINSPIN REEL SR-30 L. Accurate Technology TWINSPIN REEL SR-30 L 5 halaman. Twinspin reel
Juga untuk Accurate Technology TWINSPIN REEL SR-30 L: Panduan Penggunaan (12 halaman)

Halaman Cetak

LINE

CAPACITIES

OPERATION

Rubber

Washer

DRAG

VARIANCE

pursuetheoutdoors.com/schematics

MODEL

WEIGHT

SR-12

26 oz.

SR-20

28 oz.

SR-30

31 oz.

SR-30 L

31 oz.

SR-50

41 oz.

Basic operation of your

Reel is no different from operating any other spinning reel except for setting the preset drag. Once

WIN

the spool is filled with line you can set the preset drag. First test the drag pressure with the preset tuned to a light drag

pressure. Turn the preset clockwise until you reach your desired drag pressure. Standard practice is to set the

drag pressure at approximately 30% of your line strength. We have lasered lines around the spool cover to give

you a reference point when turning the preset.

(Make sure to keep the rubber washer on the preset well lubricated. If it is dry it will move with the spool

when line is pulled off the reel in drag mode.)

Removing the Spool - Turn the preset lock counter-clockwise to remove the spool. Do not turn the preset

to remove the spool, only turn the preset lock. Pull the spool off the spool shaft. When putting the spool

Preset

back onto the reel make sure to turn the spool slightly to align it with the cross pin on the spool shaft.

Lock

Replacing the Preset - Tighten the preset lock by turning it clockwise.

Reference

Marks

Thanks to the

exclusive Twin Drag technology, the drag tension you set will vary no more than one pound when line is

WIN

pulled off the reel at any speed! Unfortunately, there is another factor which causes drag variance that needs to be accounted for. This

factor is based on how full the reel is with line. When the spool is filled, the line is being pulled off a high point on the spool. As the

amount of line on the spool reduces, the line is pulled from a lower area on the spool. There is less leverage used when the line is

pulled at a lower level, which means the line needs more force to move the spool against the drag. The drag setting has not been

decreased, but the line will encounter increased tension. (The drag pressure will approximately double when 25% of the line has been

removed from a full spool.)

M O N O LINE CAPACITY

GEAR RATIOS

lbs./line dia. inches/yds.

6:1

12/.014/350

6:1

30/.022/250

6:1

30/.022/325

4:1

30/.022/325

4:1

30/.022/325

BRAID LINE CAPACITY

lbs./yds

50/300

50/425

80/300

130/450