Accurate Technology ProScale Panduan Memulai Cepat - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pembacaan digital Accurate Technology ProScale. Accurate Technology ProScale 17 halaman. Flush mount readouts
Juga untuk Accurate Technology ProScale: Panduan Pengguna (20 halaman)

Halaman Cetak

Common Error messages

Message

no Enc

no Pos

b fail

f fail

P fail

LOCK

P LOCK

no oFF

MON flashing

no Co

uL, LL

Manual Part # 800-1403-001 Revision 06-01-2020

There is not an encoder connected to the readout, or the

connected encoder has a fault.

The readout has not been calibrated yet.

The battery in the readout needs to be replaced

immediately.

The readout cannot display fractional values larger than

399 63/64 inches.

The battery in the readout needs to be replaced

immediately. Check programming values after new battery

is installed.

The keypad is LOCKed, but an attempt was made to

change the calibration. Unlock keypad to fix, see page 6.

The keypad is LOCKed, but an attempt was made to

change the calibration. Change Pr3 to fix, see page 11.

Offsets are disabled, but an attempt was made to apply an

offset value.

Monitor mode is turned on, and the system is out of the

allowable position.

Non-linear compensation is enabled, but there is no look-

up data for the displayed measurement.

Limits mode is turned on, and a limit has been exceeded.

What it means

Page 13 of 16