AXTRA AX-BC36 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengisi Daya Baterai AXTRA AX-BC36. AXTRA AX-BC36 10 halaman.

8-Stage Charging Steps:

Step 1: Diagnostics

Checks the battery voltage to make sure battery connections are good and the battery is in a

stable condition before beginning the charge process.

Step 2: Recovery

Initializes the Recovery process, if needed, the charger will perform deeply discharged or

sulfated (desolations) batteries by pulsing small amounts of current.

Step 3: Soft Start

Begins bulk charging process with a gentle (soft) charge.

Step 4-5: Bulk

The bulk charging process continues using both a High Rate or Medium Rate charge so that the

battery will return 80% capacity, and it will indicate by 25%, 50%, 75% charging level.

Step 6: Absorption

It brings the charging level to 90%, the battery charger will deliver small amounts of current to

provide a safe, efficient charge and limit battery gassing.

Step 7: Trickle

Battery is fully charged and ready to use, indicated by the 100% Charge LED illuminate solid

Green. In this step, the battery charger will only deliver enough current to keep the battery in

full charge. If the battery sends signal to the charger that requires more current, then the

battery charger will switch to maintenance stage.

Step 8: Maintenance

The Charger will continuously monitor the battery voltage to determine if a maintenance

charge should be initiated. If the terminal voltage falls below 6.4V (6V) and 12.8V (12V), the

charger will start the maintenance cycle until voltage reaches 7.2V (6V) and 14.4V (12V) and

Page | 9