Arcam Solo movie 5.1 Catatan Instalasi Khusus - Halaman 4
Jelajahi secara online atau unduh pdf Catatan Instalasi Khusus untuk Penerima Arcam Solo movie 5.1. Arcam Solo movie 5.1 17 halaman.
Halaman Cetak
Answer codes
The following answer codes are defined:
Status update
Command accepted, and complete
Command accepted, currently processing
Zone Invalid
Command not recognised
Parameter not recognised
Command invalid at this time
Invalid data length
Unless detailed otherwise, the data returned is valid only when the answer code is 'Status update' or
'Command accepted, and complete'. When 'Command accepted, currently processing' is returned, the
data returned is the data which is currently being processed.
Status changes
Note that Solo Movie shall transmit messages whenever its status changes. These messages shall be
transmitted by Solo Movie at asynchronous intervals.
State changes as a result of other inputs
It is possible that the state of Solo Movie may be changed as a result of user input via the front panel
buttons or via the IR remote control. Changes resulting from these inputs shall be relayed to the RC
(using the appropriate message type) as they occur.
For example, if the user changed the front panel display brightness using the
control, a display message (defined below) would be sent to the RC. A similar action would be taken for
all other state changes.
Unless stated, all RS232 commands have an associated status message.
Example command and response sequence
As an example, the command to set the front-panel display of the Solo Movie to 'full brightness' (defined
below) is as follows:
STR
0x21
Assuming that the command was accepted by the DVD player and is being processed, the DVD player
responds to this command with the following sequence:
STR
0x21
Note: RS232 control is disabled if the iPod option is enabled.
RS232
Arcam (A&R Cambridge Ltd), Pembroke Avenue, Waterbeach, CAMBRIDGE, CB25 9QR, England
(solo movie)
4
Zone
CC
DL
0x01
0x0A
0x01
Zone
CC
AC
0x01
0x0A
0x02
+44 (0)1223 203200 www.arcam.co.uk/extranet
0x00
0x01
0x02
0x82
0x83
0x84
0x85
0x86
button on the remote
DISP
Data
ETR
0x04
0x0D
DL
Data
ETR
0x01
0x04
0x0D