3Com CoreBuilder 9000 Panduan Instalasi
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih 3Com CoreBuilder 9000. 3Com CoreBuilder 9000 13 halaman. 16 mb expansion memory card installation guide enterprise switch
Juga untuk 3Com CoreBuilder 9000: Panduan Instalasi (13 halaman), Manual (8 halaman), Manual Penghapusan dan Penggantian (12 halaman)
Halaman Cetak
®
Introduction
Audience
Description
Safety Precautions
16 MB Expansion Memory
Card Installation Guide
For the CoreBuilder
The 16 Megabyte (MB) expansion memory card for the 3Com
CoreBuilder
9000 Enterprise Management Engine (EME)
™
supports versions of EME software later than Version 2.0.1.
Versions of software that are later than 2.0.1 require the 16 MB
expansion memory card to run all features.
This document provides the basic information that you need to
install the 16 MB expansion memory card into the EME:
1 Unpack the 16 MB memory card.
2 Remove the currently installed EME from the chassis.
3 Remove the 4 MB card.
4 Insert the 16 MB card.
5 Reinstall the EME into the chassis.
6 Verify EME operation.
Before you remove the EME from the chassis, read "Safety Precautions"
and "Handling Precautions" in this guide.
This guide is intended for trained technical personnel only. Do not
attempt to remove, install, or replace a CoreBuilder 9000 EME or
a memory card if you have not had the proper training from 3Com.
For training information, call 1-800-NET-3COM.
Be sure that you follow all safety precautions when you install or
replace components in a CoreBuilder 9000 system. To avoid
electric shocks, burns, or equipment damage, read and follow
these warnings:
WARNING: Allow only trained service personnel to install, remove,
or replace an EME or a memory card.
™
9000 Enterprise Switch