Axxess AX Series Panduan Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Mobil Axxess AX Series. Axxess AX Series 8 halaman.

CONNECTIONS TO BE MADE

3.5mm jack steering wheel control retention:

• The 3.5mm jack is to be used to retain audio controls on the steering wheel.

•

For the radios listed below, connect the included female 3.5mm connector with stripped leads,

to the male 3.5mm SWC jack from the AX-TYAMP2-SWC. Any remaining wires tape off and disregard.

•

Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/White

wire of the connector. Then connect the remaining steering wheel control wire, normally

Brown/White, to the Brown wire of the connector .

•

Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.

•

Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow wire

to the Brown wire.

Note: If your Kenwood radio auto detects as a JVC, manually set the radio type to

Kenwood. See the instructions under changing radio type.

•

XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.

•

Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold

separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.

Note: The radio must be updated to rev. 2.1.4 or higher software.

•

Universal "2 or 3 wire" radio: Connect the steering wheel control wire, referred to as Key-A

or SWC-1, to the Brown wire of the connector. Then connect the remaining steering wheel

control wire, referred to as Key-B or SWC-2, to the Brown/White wire of the connector. If the

radio comes with a third wire for ground, disregard this wire

Note: After the interface has been programmed to the vehicle, refer to the manual

provided with the radio for assigning the SWC buttons. Contact the radio manufacturer

for more information.

•

For all other radios: Connect the 3.5mm jack from the AX-TYAMP2-SWC harness into the jack on

the aftermarket radio designated for an external steering wheel control interface. Please refer to

the aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.

(CONT)

With the key in the off position:

• Connect the 16-pin harness with stripped leads, and the AX-TYAMP2-SWC harness, into the

Attention! Do not connect the AX-TYAMP2-SWC harness to the wiring harness in the vehicle just yet.

Attention! If retaining steering wheel controls, ensure that the jack/wire is connected to the radio

before proceeding. If this step is skipped, the interface will need to be reset for the steering wheel

controls to function.

interface.

REV. 7/24/2018 INSTAX-TYAMP2-SWC