Axxess AX-AU12-SWC Panduan Petunjuk Instalasi - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Mobil Axxess AX-AU12-SWC. Axxess AX-AU12-SWC 12 halaman. Data interface with swc for audi
Halaman Cetak
Attention! This interface will work with models that are either Bose amplified, or non-Bose
amplified. Please follow the instructions carefully for your model vehicle. Failure to do so will
result in improper sound. If you are unsure if your vehicle is Bose amplified or not, please contact
your local dealership.
For models equipped without a Bose sound system:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• Connect the Blue/White wire to the amp turn on wire.
• Connect the Purple RCA jack to the right rear RCA output.
• Connect the Green RCA jack to the left rear RCA output.
• Disregard the Gray RCA jack, it will not be used in this application.
• Disregard the White RCA jack, it will not be used in this application.
The following (3) wires are for multimedia/navigation radios that require these wires. If not
required, tape them off and disregard them.
• Connect the Blue/Pink wire to the VSS/speed-sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Tape off and disregard the following (9) wires, they will not be used in this application:
Purple, Purple/Black, Green, Green/Black, Gray, Gray/Black, White and White/Black.
CONNECTIONS TO BE MADE
(LD-BX-AU2 APPLICATIONS)
From the LD-BX-AU2 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue/White wire to the amp turn on wire.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Tape off and disregard the following (4) wires, they will not be used in this application:
Purple, Purple/Black, Green and Green/Black.
Continue to 3.5mm jack steering wheel control retention
REV. 7/19/2018 INSTAX-AU12-SWC
5