Digicom Archimede SMS Buku Panduan Operasional - Halaman 16
Jelajahi secara online atau unduh pdf Buku Panduan Operasional untuk Sistem Keamanan Digicom Archimede SMS. Digicom Archimede SMS 18 halaman. Remote alarm system
Halaman Cetak
3.1.8 Verify the GSM Signal Strength
To verify the GSM signal strength #CONFIG1# is sent to the ArchimedeSMS.
The unit will respond back with a message similar to this example.
ARCHIMEDE HOME
I VODAPHONE
GSM SIGNAL: GOOD
The signal strength can vary from EXCELLENT, GOOD and POOR and in the event
that the signal is POOR it is advisable to move the position of the unit or substitute
antenna for a higher gain one. (Contact Digicom).
In the event that the Archimede SMS is operated out of the SIM suppliers area it may
go into roaming in which case the message would indicate for example I VODAFONE
ROAMING.
Please note roaming charges can be substantially higher than normal.
3.2 Verifying and Alarm, Control and Battery Status.
To control the status of all the inputs, outputs and battery it is sufficient to send the
following message.
#TEST#
The Archimede after a few seconds will respond with the following type of message.
ARCHIMEDE HOME
1) STATE: ACTIVE
2) ALARM DOOR OFF
3) N.C.
4) ALARM GATE OFF
5) N.C.
6) ALARM GARAGE OFF
7) ALARM WINDOWS OFF
8) N.C.
9) POWER ON
10) AIR CONDITIONER ON
BATTERY: CHARGED
3.2.2 Management of the Control Relay
The control relay in the Archimede can be opened and closeed by sending an SMS
message as follows:
#OUTPUT ON#
(This causes the relay to close)
#OUTPUT OFF#
(This causes the relay to open)
16