Axxess AX-CH013-SWC Panduan Petunjuk Instalasi
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Peralatan Perekaman Axxess AX-CH013-SWC. Axxess AX-CH013-SWC 12 halaman. Chrysler data interface with swc2004-up
INTERFACE COMPONENTS
• AX-CH013-SWC interface
• LD-BX-CH3 harness
• LD-BX-CH4 harness
• 16-pin harness with stripped leads
APPLICATIONS
See inside front cover
AxxessInterfaces.com
Chrysler Data Interface with SWC
*Visit AxxessInterfaces.com for up-to-date vehicle specific applications.
INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains audio controls on the steering wheel
• Retains safety chimes (LD-BX-CH4 applications)
• Can be used in both amplified and non-amplified models
• Retains balance and fade (non-amplified models only)
• Retains Blind Spot Detection (if equipped)
• Includes antenna adapters for both generations of vehicles
• Micro "B" USB updatable
• 4-pin harness with stripped leads
• Female 3.5mm connector with stripped lead
• Antenna adapters (2)
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
AX-CH013-SWC
I N S TA L L AT I O N I N S T R U C T I O N S
2004-up*
TABLE OF CONTENTS
Connections to be made ................................... 3-6
- For models without an amplifier .......................3
- For models with an amplifier ............................4
Installing the AX-CH013-SWC ................................5
Programming the AX-CH013-SWC ........................6
Adjusting the AX-CH013-SWC ................................6
Steering wheel control settings ....................... 7-9
- L.E.D. feedback ....................................................7
- Changing radio type ...........................................7
Troubleshooting ................................................... 10
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
• Small flat-blade screwdriver
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
REV. 7/25/18 INSTAX-CH013-SWC