Axxess AXTC-FD3 Panduan Petunjuk Instalasi - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Elektronik Mobil Axxess AXTC-FD3. Axxess AXTC-FD3 12 halaman. Ford swc (steering wheel control) and data interface 2020-up
Halaman Cetak
If the AXTC interface's LED light didn't go out at the end of the radio programming sequence, or showed the wrong radio installed*, follow the
steps below to trace down where the problem may lie. The final LED feedback light will also flash
solid Green. If any of the following steps are performed, reset and reprogram the interface per the vehicle specific document. Take note where
SWC is worded means Steering Wheel Control.
* Reference the Radio LED Feedback table at the end of this document.
The 3.5mm jack from interface should be plugged into the SWC Input from the radio. Make sure it isn't
Is the
plugged into the Bluetooth Mic or AUX Input. If unsure which input to use, refer to the manual provided with
3.5mm jack
the radio, or contact the radio Manufacturer.
connected?
Note: Some radios use a wire an for SWC instead
Was the
Reference the Radio LED Feedback table. Boss, Clarion, and Eclipse have different radio types and the wrong
correct
radio type may have been auto detected. Reference the Changing Radio Type document to change the radio
radio type
type. Also refer to the radio specific troubleshooting steps on the following page.
detected?
If all troubleshooting steps have been performed and the interface still doesn't go solid
Update
the final programming sequence, update the interface to the latest firmware, then try programming once
the
more. If the interface still doesn't go solid Green, contact Tech Support at 1-800-253-TECH. Take note to
interface
be prepared to perform some tests in the vehicle when you contact Tech Support, and have the Product ID
Number on the bottom of the interface noted.
Integrate •
© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
RADIO TROUBLESHOOTING
Red
Product
ID Number
Update
Port
AxxessInterfaces.com
REV. 6/13/19
AXTC SERIES
slowly or turn solid Red, instead of turning
Green
at the end of
XXXX-XXX-XXXX
Back of interface
Continued on the next page