Circuit Abbey ADSRjr Expander Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Inverter Circuit Abbey ADSRjr Expander. Circuit Abbey ADSRjr Expander 9 halaman. Envelope generator

Halaman Cetak

Setup & Installation

To install you ADSRjr, first set up the jumpers.

"Time" jumpers: A bit misnamed, as they are used to set the desired curves. An installed jumper

sets that segment for exponential, removing the jumper sets the segment for linear. Each segment

has its own jumper, and can be set independently from the others. For example, a linear attack

and expo decay and release. Ships with all three jumpers installed.

Gate jumper: Routes the Doepfer bus gate signal to the gate jack. Remove to disable. Ships with

Doepfer bus enabled.

+5V jumper: Sets the source of the 5 volts used internally in the module. Ships in the +12V

position to derive 5 volts from the +12 volt supply. If your case has the 5 volt rail powered you can

move the jumper to the "Buss" position to offload the +12 volt supply.

"Pull for 8V": Another misnomer. Module ships with 0-5V output range. For 0-10V range, remove

this jumper.

Now you can attach the power cable as shown, making sure the red stripe is in the correct

position, and install the module in your case.

Install power

cable thusly