Epson ActionLaser 1400 Panduan Pengguna - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Printer Epson ActionLaser 1400. Epson ActionLaser 1400 30 halaman. Flatbed inkjet printer
Juga untuk Epson ActionLaser 1400: Panduan Pengguna (8 halaman), Baca Panduan Pertama Ini (27 halaman)
Halaman Cetak
Flatbed Inkjet Printer
Note：before clicking" Ensure"，the position of flatbed should at " initialized position"。
In chapter "the correct way to use the flatbed printer", we will indicate the way of setting
the flatbed to initialized position。
D．The Correct way to use the printer.
One．Operate the printer
1,Connect to power, turn on the switcher on the front panel of the printer, LCD display will turn on and
display: "wait for online" , the LED Indicator of "power" on front panel will turn red。
Note：
1．Before using the printer, please have full read to the "Note Item" of the left part。
2．Please don't place eyewinker on the printer, it might have bed effect to the printer for emitting the
heat, and please also avoiding liquid to splash in the printer, unless, it might destroy the printer。
3．Please open the cover when you in situation for operating to the continuous ink supply system,
if the printer in situation of working, please don't open the cover, and don't touch the print-head,
unless, it might have damage to the printer。
4．When printer in situation of automatic cleaning & self-test, there might have some noise be
released, this is a normal situation.
5．Please ensure the cartridge has get back to initialized position when the printer is OFF duty, and
the cover should be closed。
Alarm： please don't touch the inner part of the printer, and don't touch any other part of the printer
for such as print-head and the else moving components, when the machine is working, unless, it
might lead to damage to your health and have bad destroy to the printer.
2．When you press the key "connect", the LED Lamp "online " will turn on, printer will have self-test,
and have automatic cleaning to the print-head, also, the flatbed will automatic move to terminal
position。
Alarm：when the flatbed in moving, there should not have remora to block it, there might cost
about 90seconds for the self-test, therefore, please do not have any other operation to the printer。
Note：please don't press the flatbed(including the status of the flatbed in position of initialized &
holding out), please also do not put the object with weight over 20kg, please don't pull the flatbed
by hand when it is in working situation, and, please do not put something under the flatbed when
it is working, this way will ensure enough space for lifting & dropping to the space of the flatbed。
3．When the printer have automatic self-test be done, the "online" LED lamp will automatic stop
flashing & turn to long lighting situation, at this time, the printer is in situation of standby, you can
now put the media in any position of the flatbed。
Note：if there have error occurred undefined, the printer could not enter standby situation, the
LED Lamp of "online"will flash for long time, at this time,please turn off the rear switcher of the
printer, and restart the printer in 5 seconds later。
4．Put media on the flatbed
a、put the media be coated on the initialize position (the surface of the printing media should be lower
of the gauge )。
１４
１４