Epson ActionPrinter 2250 Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Printer Epson ActionPrinter 2250. Epson ActionPrinter 2250 13 halaman. Epson printer specification sheet

Halaman Cetak

Tips for using continuous paper

You can adjust the top-of-form position temporarily. Open the

printer cover and turn the gear marked by + and - signs to

adjust the position, This adjustment is lost when you turn off the

printer or feed the paper backward to the paper-park position.

paper-park position

If you want to change the top-of-form position permanently,

adjust it with the default-setting mode.

Each time you turn on the printer with paper loaded, it reverses

the continuous paper to the paper-park position and then

advances it to the next top-of-form. Always remove your printed

sheets before you turn off the printer to keep the top-of-form

position accurate.

Note: When you set the back-feed setting to Disable in the

default-setting mode, the printer does not feed the paper

backward even if you press the

Removing the push tractor

Tear off any printed pages. Press the

the same time to feed the remaining paper backward to the

paper-park position. Remove the paper from the push tractor.

Always tear off the printed document and

CAUTION:

excess paper before feeding paper backward. Never feed

more than one page backward through the printer.

2. Turn off the printer and lower the paper-release lever to the

single-sheet position. Then pull the push tractor straight down

and out of the printer.

9-Pin Printers

and

buttons or you

LF/FF

FONT

and

buttons at

LF/FF

FONT

3. Replace the paper guide.

Using the tear-off feature

When you use continuous paper, the tear-off feature makes it easier

to tear off the last printed sheet and save the paper normally lost

between documents.

Note:

You can tell the printer to feed the perforation of your paper to

either the edge of the printer cover or approximately 80 mm

(three inches) beyond, by setting the tear-off option,

When you set the back-feed setting to Disable in the default-

setting mode, the tear-off feature does not work.

Here's how the tear-off feature works:

1. When the printer finishes printing the last page and the print

head moves to the top-of-form position on the next page, the

printer automatically advances the paper to the tear-off position.

2. The READY light ( m ) blinks to indicate the printer is in tear-off

mode.

3. You can then easily tear off the page along the perforation.

4. When the printer receives data, it feeds the paper backward to

the top-of-form position and the printer begins printing.

Switching between continuous paper and single sheets

When you use the push tractor, you can easily switch to single-sheet

printing without removing the continuous paper supply.

Switching to single sheets

Here's how to switch from continuous paper to single sheets:

1. If you have a printed document still in the printer, tear off the

printed pages and then press the

same time to reverse the remaining paper back to the paper-park

position.

Always tear off printed pages before feeding paper

backward; feeding too many sheets backward can

Never feed labels backward. They can easily peel off of

7 / 1 4 / 9 2

ActionPrinter 2250

and FONT buttons at the

LF/FF

AP-2250-7