Epson AcuLaser C8600 Referensi Cepat - Halaman 8
Jelajahi secara online atau unduh pdf Referensi Cepat untuk Printer Epson AcuLaser C8600. Epson AcuLaser C8600 23 halaman. Epson aculaser c8600: specifications
Juga untuk Epson AcuLaser C8600: Setup Manual (44 halaman), Spesifikasi (1 halaman)
Halaman Cetak
Need Memory
The printer has insufficient memory to
complete the current print job. Cancel
printing by deleting it from the print queue
on your computer, or by pressing the
Cancel button on the printer.
To clear this error message, select Clear
Warning from the control panel's Reset
Menu. See "How to access the control panel
menus" for instructions.
To prevent this problem from happening
again, add more memory to your printer as
described in "Memory module" in the
Reference Guide.
Offline
The printer is not ready to print. Press the
Start/Stop button .
Optional RAM Error
The optional memory module may be
corrupted or incorrect. Replace it with a new
one.
Outbin Select Error
Printouts are not output to the specified
output tray, but to another tray due to a
printing restriction.
Paper Out XXX YYY
There is no paper in the specified paper
source (XXX). Load paper of the indicated
size (YYY) into the paper source.
Paper Set XXX YYY
The paper loaded in the specified paper
source (XXX) does not match the required
paper size (YYY). Replace the loaded paper
with the correct size paper and press the
Start/Stop button to resume printing. Or
press the
Job Cancel button to cancel the
print job.
EPSON AcuLaser C8600 Quick Reference
If you press the Start/Stop button without
replacing the paper, the printer will print on
the loaded paper even though it does not
match the required size.
Job
Photocondutr Trouble
The installed photoconductor unit has a
problem. Turn off the printer, remove the
photoconductor unit and install a new
photoconductor unit. See "Replacing the
photoconductor unit" in the Reference Guide.
Print Overrun
The required time to process the print data
exceeded the print engine speed because the
current page is too complex. Press the
Start/Stop button to resume printing. Or
press the
print job. If this message appears again,
select On as the Page Protect setting in the
control panel's Setup Menu.
If you continue to receive this message when
printing a particular page, try simplifying
the page by limiting the number of graphics
or reducing the number and size of fonts.
You can also add more memory to the
printer as described in "Memory module" in
the Reference Guide.
PS3 Hard Disk full
The memory allocated for writing PostScript
3 commands on the optional Hard Disk
Drive is full.
To clear this error, select Clear Warning
from the control panel's Reset Menu. See
"How to access the control panel menus" for
instructions.
RAM Check
The printer is checking the RAM.
Job Cancel button to cancel the
Status and Error Messages (5/8)