Arch Environmental Equipment CTS 9000 IRRD Panduan Pengoperasian dan Pemasangan - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemasangan untuk Sensor Keamanan Arch Environmental Equipment CTS 9000 IRRD. Arch Environmental Equipment CTS 9000 IRRD 4 halaman. Infra-red belt rip detection unit

Halaman Cetak

INSTALLATION AND OPERATION

Tools Required For Installation:

The following tools are required for the installation of the belt misalignment unit :

1. Drill and extension.

2. ½ Inch Diameter Drill Bit.

3. 2 x 9/16 inch wrenches.

4. Adjustable Wrench.

5. 6mm flat screw driver.

6. 3mm flat screw driver.

Installation:

To install the CTS 9000 IRRD drill ½" holes into the conveyor structure matching the holes

on the CTS 9000 IRRD base plate, place the CTS 9000 IRRD on the conveyor structure

over the holes and bolt it down with supplied bolts. To connect the CTS 9000 IRRD, refer to

the CTS 9000 IRRD Control Box Wiring Diagram, and connect a cable to the COM terminal

and the N/O (Normally Open) or N/C (Normally Closed) contact depending on the

application.

Operation:

If an object is protruding through the belt as it passes the CTS 9000 IRRD it will break the

infrared beam and the unit will trip. If there is a longitudinal rip in the conveyor belt material

will fall onto the catch plate which then builds up and breaks the infra-red beam causing the

TYPE: CTS 9000 IRRD

ph 220VAC

ph 110VAC

WASH

LED1

N/O

COM

N/C

TRIP

LED2

LOCK

OUT

RESET P/B

LED1

WASH P/B