CREE LIGHTING OSQ Series Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Lampu luar ruangan CREE LIGHTING OSQ Series. CREE LIGHTING OSQ Series 3 halaman. Led area light, trunnion mount

Halaman Cetak

DO NOT remove knockout

Luminaire Cord

1 2 3 4 5

DRV

STEP 7:

Route the cord coming from the luminaire head through the Trunnion

Mount. See Figure 2.

STEP 8:

Slide the mounting arm of the luminaire over the Trunnion Mount as

shown in Figure 2.

STEP 9:

Tighten (4) 3/8-16 socket head set screws located on the top of the

mounting arm with a 3/16" Allen wrench to 85 in-lbs (9.6 N•m). See

Figure 2.

STEP 10:

See the Electrical Connections section for wiring instructions.

NEMA

RECEPTACLE (OPTIONAL)

NOTE: When inserting a control unit into the nema receptacle and

rotating control unit to lock in, the engagement force may exceed

the rotational force of the receptacle. If this occurs, the receptacle

and control unit can be rotated clockwise until the hard rotation stop

is reached on the receptacle and locking engagement between the

receptacle and control is achieved. Once engaged, the control unit and

receptacle can be turned counter clockwise to the desired orientation.

Always verify proper installation by pulling up on the control module to

confirm that it is locked into the socket.

STEP 1:

Remove protective cap.

STEP 2:

Rotational adjustment of the photocontrol receptacle is tool-less . DO

NOT loosen/tighten the screws securing the receptacle to the housing.

2 of 3

(4) 3/8" Socket Head

Set Screws

Trunnion

Mount

DRV

CRTL

9 1 2

Both Style Switch Knobs are Shown in Position #1

1 2 3 4 5

DRV

STEP 3:

Engage/install photocontrol into photocontrol receptacle on top of

luminaire.

STEP 4:

If necessary, rotate photo-control so its photo-eye is aimed in the north

direction. Some photo-controls operate best somewhere between

north-west and north-east.

FIELD ADJUSTABLE DIMMING - (OPTIONAL)

NOTE: This luminaire may be provided with field adjustable dimming.

If so, luminaires leave the factory adjusted to the maximum setting

specified when ordered. Visit www.creelighting.com/products for

product specification sheets.

STEP 1:

The Dimming module is located inside the luminaire. Open the

luminaire door cover by loosening the (5) screws. See Figure 3.

STEP 2:

Establish the desired input power multiplier by referring to the product

dimming spec sheet and turn the switch to the correlating position

STEP 3:

Adjust the Dimming Module, see Figure 4, to the selected position and

reinstall the cover ensuring no wires are pinched.

Luminaire Cover Door

CRTL

LPN00316X0003A0_C