ABB RHD8000 Series Petunjuk Manual - Halaman 15

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Pengontrol ABB RHD8000 Series. ABB RHD8000 Series 17 halaman. Electrical part turn actuators for continuous modulating control (contrac)

Halaman Cetak

11.3.2

Mounting

The toothed gear pair of the position sensor is held in place by a tension spring (3),

to ensure backlash-free motion when the direction of rotation is reversed.

- set the stop pin to the center position, as shown in Figure 14.

- align the sensor and its gears with the actuator; set the first toothed gear in

09:00 o'clock position (fig. 15) onto the drive shaft gear (4).

- slightly move the sensor back and forth to pre-tension the toothed gears with the

difference "z" until the second toothed gear snaps in.

- fasten the screws (1) tightly.

- fasten sensor cable plug on sensor pcb

(r00329x1)

Fig. 14: Position sensor

After mounting is completed readjust the actuator range as described in the setup

section of this manual.

sensor cable

Fig. 15: Mounting position (Example shows RHD 500)

position sensor