ARCHITETTURA SONORA CUBE400 Panduan Servis
Jelajahi secara online atau unduh pdf Panduan Servis untuk Pembicara ARCHITETTURA SONORA CUBE400. ARCHITETTURA SONORA CUBE400 6 halaman.
Halaman Cetak
CUBE400 SERVICE MANUAL
0.0 > Tools:
prepare the following tools on a work surface
A _
B _
Cutter
2 Allen Key
#3 and #7
0.1 > Set Up:
before start working on the Cube, carefully follow these steps:
In case the Cube comes with concrete
de ector, make sure to remove it before
overturning it. Pay attention not to scratch the
legs during this operation.
1.0 > Disassembly Procedure:
C _
D _
Phillips
2 Flat
Screwdriver
Wrenches #17
Turn the cube upsidedown on a soft
surface (base facing up), ...
1 >
Using the Cutter (A) remove the
net protecting the cable by cutting the
heat-shrinking sheath locking it it, and
leave the cable naked.
3 >
Using the Allen Key #3(B)
unscrew the 4 M5X30 screws and
remove the stainless steel frame
protecting the coaxial. The coaxial
remains untied as well.
E _
F _
Torque
Welder
Wrench #7
(40 W min)
.. possibly using the original protective
packaging, to avoid possible scratches.
G _
Hot
Air Gun
2 >
Using the Allen Key #7(B) unscrew
the 4 M10 screws securing the base,
making sure to always unscrew the
screw opposite to the previous one and
paying attention not to scratch the legs.
Lift the base and at the same time pull
out the cable from the column holding it
vertically to facilitate the movement of
the base.
4 >
Lift the coax and turn it over the
inner ange of the Cube. Desolder the
quadripolar
cable
from
connections on the coaxial speaker,
quickly enough to avoid thermal damage
to wires and internal connections of the
driver. Be sure to remember the colors of
the phases. (Brown > +Woofer; Green >
-Woofer; Yellow > +Tweeter; White >
-Tweeter)
H _
2 Nylon
Cable Ties
the
four