Creek Audio AMBIT TUNER Buku Petunjuk - Halaman 4

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Penerima Mobil Creek Audio AMBIT TUNER. Creek Audio AMBIT TUNER 10 halaman. Plug-in fm/am tuner

Halaman Cetak

na to the AM antenna clips on the rear panel, either way around. Press the buttons down

to insert the bare wires and release them to grip the wires. Place the loop away from the

amp and somewhere that is not going to block the AM signal. Rotate the loop to point at

the station transmitter, for best results. This may vary from station to station, as the loca-

tion of each station will be different.

GETTING STARTED IN YOUR REGION

As you may be operating the Receiver in a region of the world where the radio standards

are different from the factory setting, it is necessary to manually select the correct, or most

appropriate region first. Power-OFF the Receiver; Press and hold the MENU button and

then press the POWER button to turn the Receiver-ON again. When the OLED display

lights-up and the

logo disappears, release the MENU button and the display will

show a Set-Up menu, including Broadcast Region. Rotate the left-hand control knob, to

select Broadcast Region. Press the knob once, to show all the available regions. Select

your region with the control knob and press it once again. To return to normal operation,

press the MENU button once more. After a couple of seconds delay the Receiver will work

with the correct settings for your region.

EVOLUTION 50A FRONT PANEL CONTROLS & OPERATION

Most of the AMBIT Tuner functions are controlled by the left-hand control knob and 3 push

buttons. To switch from Line inputs to the Tuner press any of the three Tuner buttons. To

return to the amplifier's LINE inputs, press the SRC (Source) button.

BAND, switches between FM and AM bands and also selects Tuner mode, for when the

Receiver was previously in Line input mode.

TUNE selects between manual tuning mode and automatic SEEK mode. Press TUNE and

rotate the left-hand knob to increment the frequency up or down to the desired station, in

either AM or FM mode. Press the knob briefly to initiate SEEK/SEARCH in the direction

last travelled by the rotary control.

PRE switches to a station preset mode. Turn the left-hand control knob to step through 99

available preset locations. Presets can be populated manually or automatically. Both meth-

ods are detailed in the paragraphs bellow.

Storing a station in a Preset location can be done several ways with the Receiver.

Page: 3