Creek Audio AMBIT TUNER Buku Petunjuk - Halaman 7
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Penerima Mobil Creek Audio AMBIT TUNER. Creek Audio AMBIT TUNER 10 halaman. Plug-in fm/am tuner
Halaman CetakReceiver was previously in Line input mode.
MODE switches between PREset mode and TUNE mode.
MONO manually forces the FM tuner into mono in three stages, for when an FM stereo
signal may be too noisy to listen to in Stereo. Normally, the AMBIT Tuner will automatically
adjust the amount of stereo separation, from full stereo to mono, to maintain a good signal
to noise.
DIM changes between three levels of display brightness. Display off is not possible.
NUMBERIC buttons 0-9
1. To tuner directly to a frequency.
2. To go directly to a Pre-set address
Numeric frequency entry: To enter a known station frequency directly, press the exact
numbers, without a decimal point, i.e. to tune to 101.1 MHz FM, enter 1011, or to tune to
909 kHz AM, enter 909. No other entry is required and if this is a valid frequency, the Re-
ceiver will automatically jump to it. It is necessary to select the desired BAND first.
Numeric Pre-set entry: Select pre-set mode, via the green MODE button. Use the button
on the handset marked -/-- once or twice to select either a 1 or 2 digit number, shown with
one or two hyphens (- or --). Now press a number or numbers directly from the handset. If
a valid memory address is entered, the Receiver will tune to it.
STORE adds stations to memory. Press STORE for 2 seconds; when the display flash-
es, select a number using SEL up / down, or use the default number flashing and press
STORE again briefly, to memorize the station into a pre-set address.
SEL, Press the top or bottom of the blue button to tune to the next Pre-set.
<< >> TUNE moves the frequency up / down.
I<< >>I SEEKs up / down.
INFO operates the same as on the front panel.
TIME displays the actual time derived from RDS information. It cannot display unless an
FM –RDS station is tuned.
Page: 6