Digigram LX6464ES Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kartu Suara Digigram LX6464ES. Digigram LX6464ES 14 halaman. Ethersound pci sound card

INFORMATION FOR THE USER

This device complies with part 15 of FCC rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits for a CLASS B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions contained in this data sheet, may

cause harmful interference to radio and television communications. However, there is

no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

* reorient or relocate the receiving antenna

* increase the separation between the equipment and the receiver

* connect the equipment into an outlet on a circuit different from that of the receiver

* consult the dealer or an experienced audio television technician.

Note:

Connecting this device to peripheral devices that do not comply with CLASS B

requirements or using an unshielded peripheral data cable could also result in

harmful interference to radio or television reception. The user is cautioned

that any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this

equipment. To ensure that the use of this product does not contribute to

interference, it is necessary to use shielded I/O cables.

•

Warning:

Electrostatic discharge (ESD) can damage several

components on the board. To avoid such damage in

handling the board, take the following precautions:

Bring the device and everything that contacts it to

ground potential by providing a conductive surface and

discharge paths. As a minimum, observe these

precautions:

Disconnect all power and signal sources.

Place the device on a grounded conductive work surface.

Ground yourself via a grounding wrist strap or by holding a grounded

object.

Ground any tool that will contact the device.