FIALA MOTORS Valach Motors VM R5-250 Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Mesin FIALA MOTORS Valach Motors VM R5-250. FIALA MOTORS Valach Motors VM R5-250 10 halaman.

Manual for motor FM_VM R5_R7 ( Date of publication 01/2018)

If the engine still does not start, it is necessary to contact an authorized service center or the

manufacturer directly.

7. Running motor

Each motor is factory-tested and adjusted to the basic setting. Use a fuel with a higher ratio of oil

(see section 3 of this manual), ie. 1:25. While running is not recommended long term exceed the

motor speed 2500 / min while controlling the temperature of the engine. Do not keep a constant

speed but motor flush with the occasional addition / slow down the gas. This mode observe about

the first 30 minutes of operation. After a short time, you can gradually increase the speed up to

higher allowed RPM . Total time of run is about 2 hours.

When thinking about the placement of the engine into the model, keep in mind that it is absolutely

necessary to ensure proper cooling. Use all screws to attach the motor to the motor mount. Engine

mount directly without dampers. Use self-locking nuts and / or thread adhesive of medium strength.

The 250 R5 is delivered due to transport and the risk of damage with the dismantled carburettor.

Preparation of the carburettor for assembly, step 1 to 3.

FIALA PROP s.r.o, Vysoká 56, 75641 LEŠNÁ , Czech Republic , e-mail: [email protected]

www.fialaprop.com

Page 6