Digikeijs DR4088OPTO Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Konverter Media Digikeijs DR4088OPTO. Digikeijs DR4088OPTO 14 halaman. Feedback module
Juga untuk Digikeijs DR4088OPTO: Buku Petunjuk (11 halaman), Manual (8 halaman), Buku Petunjuk (12 halaman), Buku Petunjuk (15 halaman)

Halaman Cetak

1. Connection Examples

DR4088RB-CS / OPTO

3.2 Programming DR4088RB with further DR4088 at S88(N) connection

It is important that the DR4088RB-xx must receive the module address once so that the DR4018RB-xx knows which module address it starts with. In addition, the

DR4088RB-xx must be informed that it consists of X times 8 feedbacks.

This means:

If another DR4088xx is connected to the S88 connection of the DR4088RB-xx, the number of modules increases from 2 to 4.

If the DR4088RB-xx a second DR4088xx is plugged into the S88 connection, the number of modules increases from 4 to 6, and so on.

etc.

Attention! A maximum of four DR4088xx can be connected to the S88 connection on each string consisting of one DR4088RB-xx. This means that the DR4088RB-xx

is assigned module address 1 and then the number of modules 10 is transferred. This means that a maximum of 80 feedbacks are available on string 1.

If a second line is now set up at the R-Bus® , it starts with module address 11. Here, too, a maximum of 4 additional DR4088xx can be connected to the S88 con-

nection of the DR4088RB-xx. The second step here is to transfer the number of modules 10 to the DR4088RB-xx. A maximum of 80 feedback modules are now also

available on this line.

3.2.1 Programming with the DR5000

Open the DR5000 Tool

Properties Call XN-FB Bus

FB Call Programming Module

Now just follow the instructions in the wizard.

Please refer to the instructions above for programming the number of modules.

Example:

DR4088RB-xx —>

DR4088xx

Modul address 1

Number of modules = 4 (x 8 feedback units)

DR4088RB-xx —>

DR4088xx —> DR4088xx —> DR4088xx —> DR4088xx

Modul address 1

Number of modules = 10 (x 8 feedback)

www.digikeijs.com

® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz

2021-07-06

Important!

When using the LN or RB module, the ext88N IN number of 16

and 8 input modules must be set to 0 on the DR5000. This can be checked if

in the feedback monitor row 1 and row 9 are white with blue and not red!

P 8