FIAM. LUXOR 1972/B Informasi Produk - Halaman 6

Jelajahi secara online atau unduh pdf Informasi Produk untuk Perabotan Dalam Ruangan FIAM. LUXOR 1972/B. FIAM. LUXOR 1972/B 17 halaman.

LUXOR Table

Art. 1972/B - 1951 - 1942

Read this information carefully before using the product and keep it for

future reference. Failure to comply carefully with the instructions which

follow may put the safety of the product and its users at risk.

Product description and intended use

• Product description and composition

The LUXOR Table - Art. Code 1972/B - 1951 - 1942 is a Table intended as an item of indoor furniture. It is manufactured from

curved float plate glass. The LUXOR Table was produced at the FIAM ITALIA SPA factory at Via Ancona 1/B, 61010 Tavullia (PU),

Italy - Tel: +39.0721.20051 - Fax: +39.0721.202432 - www.fiamitalia.it

• Intended use

The article known as LUXOR is designed and built to serve as a Table for indoor use and must therefore be used only for this

purpose and no other.

For more information about the product's intended use please refer to section "2) SAFETY INSTRUCTIONS".

To ensure that our product is used in the conditions of the utmost safety, we urge you to comply with the safety instructions

provided below. If in doubt or if you require further information concerning the use of the product, please contact us on the

telephone numbers stated in this document.

• Transporting and storing the LUXOR Table in the original packaging

The LUXOR Table, in its original packaging (2 packs; one for the legs and one for the top), must be transported taking the greatest

care to prevent knocks and shaking. It must be stored indoors in a dry place.

Place the LUXOR Table in the original packaging, in the horizontal position. The arrows on the label on the packaging must be

vertical and pointing upward.

Never place weights or loads in excess of 200 Kg on the original packaging, since exceeding this weight may cause the breakage

of the article.

The LUXOR Table in the original packaging weighs min 170 kg to max 220 kg.

It must therefore be placed on surfaces capable of supporting its weight.

• Removing the packaging - assembly

To remove the original packaging of the LUXOR Table, proceed as follows.

a) Place the packaging crate horizontal. The arrows on the labels on the outside must be vertical and pointing upward.

b) Open the packaging crate and remove the sheets of polystyrene. Do not use hammers, saws, cutters or other tools which may

damage the LUXOR Table.

c) Remove the frame of the LUXOR Table from its packaging. At least two people are required for this operation.

d) Remove the top of the LUXOR Table from its packaging and place it on the frame. At least two people are required for this

operation. Wear gloves which assure a good grip on the float glass.