Digilent Pmod ESP32 Panduan Referensi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Referensi untuk Unit Kontrol Digilent Pmod ESP32. Digilent Pmod ESP32 8 halaman.

4. If you are using an FPGA as your UART controller, disregard this step, but if

there is more than one UART controller in your design, note which UART

controller is connected to the Pmod ESP32.

4. Set the serial terminal (Putty, Minicom, CoolTerm) to use 115200 baud with 8 data bits,

1 stop bit, no parity

5. Send the characters "AT" followed by the <CR> and <NL> characters. You may be able

to set your serial terminal software to automatically add the <CR> and <NL> characters

on the end of any transmission.

6. In your terminal, you should see the Pmod echo back your "AT" command to you and

also respond with "OK"

7. You are now set to send AT commands to your Pmod ESP32. Try to connect it to your

local wireless network by sending the command AT+CWJAP="your network name","your

network password".

https://reference.digilentinc.com/reference/pmod/pmodesp32/reference‐manual 4‐4‐18