Cres Cor H138NPS36CLCMQRL i7 Panduan Petunjuk Pengoperasian dan Pemeliharaan - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian dan Pemeliharaan untuk Peralatan Makanan Komersial Cres Cor H138NPS36CLCMQRL i7. Cres Cor H138NPS36CLCMQRL i7 9 halaman. Hot cabinet
Halaman Cetak
5925 Heisley Road • Mentor, OH 44060-1833
DOOR ADJUSTMENT:
Door latches and hinges sometimes loosen and/or need
adjustment after a period of time. Gaps between the
door and the cabinet will cause heat loss.
Test the door to see if it closes properly:
a) Close the door onto part of a piece of paper and try
to pull it out.
b) Do this on the edges on the latch side and then on the
hinge side. If it pulls out without some resistance, the
latch and/or hinges need to be adjusted.
Loose Screws: If the screws are loosening, use liquid
thread lock (non-permanent) to keep them tight.
How to adjust/tighten door latch:
Fig. 1. For vertical adjustment
(Up and down movement):
a) Loosen two (2) screws located in magnetic strike
on cabinet.
b) Move strike up or down for alignment to magnet
on latch.
c) Tighten screws to secure.
Fig 2. For horizontal adjustment
(Greater or lesser magnetic draw):
a) Loosen four (4) screws in latch on door.
b) Move latch forward or backward to adjust
magnetic draw.
c) Tighten screws to secure and then test the door.
MAINTENANCE INSTRUCTIONS
FL-2331-LC
Holding Cabinet
Rev. 11 (4/14)
Page 5 of 9
Figure 1 Strike
Figure 2 Latch