Digilent chipKIT Network Shield Panduan Referensi Dan Panduan Pengguna - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Referensi Dan Panduan Pengguna untuk Perangkat Keras Jaringan Digilent chipKIT Network Shield. Digilent chipKIT Network Shield 11 halaman. Chipkit network shield board
Juga untuk Digilent chipKIT Network Shield: Panduan Referensi (11 halaman)
Halaman CetakchipKIT Network Shield Reference Manual
6) CAN2 Connector
This connector provides access to the signals for CAN2.
7) CAN1 Connector
This connector provides access to the signals for CAN1.
8) Digital Signal Connector
This connector provides most of the signals used by the Ethernet and USB interfaces from
the Max32 board to the Network Shield board. The remaining signals are passed through
the Network Shield.
9) J7 – I
2
C #1 Daisy Chain Connector
This is a 2x4 pin header connector that provides access to the I
as well as power from the 3.3V power bus and ground. This can be used to extend the I
bus off of the board and to power external I
2
of I
C peripheral modules that can be accessed using this connector.
10) J7 – I
2
C #2 Daisy Chain Connector
This is a 2x4 pin header connector that provides access to the I
as well as power from the 3.3V power bus and ground. This can be used to extend the I
bus off of the board and to power external I
board pull-ups are adjacent to this connector.
11) Digital Signal Connectors
Some of the signals used by the Network Shield are provided on these connectors. The
rest of the signals are passed through the Network Shield.
www.digilentinc.com
Copyright Digilent, Inc. All rights reserved. Other product and company names mentioned may be trademarks of their respective owners.
2
C signals SDA and SCL
2
C device. Digilent has cables and a selection
2
C signals SDA and SCL
2
C device. The jumpers for disabling the on-
2
C
2
C
page 3 of 11