Digilin Cobra Panduan Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Lampu luar ruangan Digilin Cobra. Digilin Cobra 2 halaman. Exterior led wall fixture
Halaman CetakCobra - Exterior LED Wall Fixture
Installation Guide
Installation
1.
Install drive gear in a dry location.
4.
Run cable to dry location for any joins and
connect to drive gear.
Wiring Diagrams
Non-Dimmable (NDM)
Non-Dim fittings are wired in parallel.
Dimmable (DIM)
Dimmable fittings are wired in series.
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
digilin.com.au
+617 3899 1267
2.
Prepare mounting surface by drilling central
hole for cable and 2 holes for mounting
fasteners.
5.
Ensure correct orientation of fitting then
secure to surface using appropriate
fasteners.
3.
Feed fitting cable through central hole.
6.
Turn on power.
www.digilin.com.au
Page 2 of 2