Digilin Flare Panduan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Lampu luar ruangan Digilin Flare. Digilin Flare 3 halaman. Wall wash uplight

Halaman Cetak
Flare - Wall Wash Uplight
Installation Guide
Conduit Mount
1.
Prepare and install conduit as required. The
Flare requires a conduit with an inner
diameter of at least 63mm for installation
and must allow for adequate depth for
fitting and cable.
4.
Apply a bead of suitable neutral cure
adhesive to the threaded side of the fitting.
7.
Run cable back to a dry location and
connect to power.
Note. Non-Dimmable fittings connect in
parallel, Dimmable fittings connect in series.
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
digilin.com.au
+617 3899 1267
2.
If present, remove the lock nut from the
fitting.
5.
Align the fitting so that the beam will shine
onto the wash surface as indicated by the
label on top of the fitting.
8.
Turn on power.
3.
Feed the cable through the conduit
6.
Press the fitting into place. Secure it into
place while adhesive cures using a suitable
tape if required.
www.digilin.com.au
Page 3 of 3