Digilin Colour Touch VW Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol Digilin Colour Touch VW. Digilin Colour Touch VW 11 halaman. Vw dmx controller fw 1.0

Halaman Cetak
Colour Touch VW - VW DMX Controller FW 1.0
User Manual
1.0 - 2 June 2021

Installation

Wiring

The Colour Touch VW has two inputs, a RJ45 and a screw terminal
block. The RJ45 carries the DMX signal and also can carry power in
for the Colour Touch VW. The screw terminal block the main
power input for the Colour Touch. The pinout for the RJ45
connector can be found in Table 1 Wiring to Cat5 cables.

Wiring to LDD Controllers

Digilin's newest range of LDD controllers use RJ45 and cat5 cables
for DMX. To connect them to a Colour Touch VW, just use a
straight through CAT5/6 cable with RJ45 plugs on either end. To
apply power to the Colour Touch VW just toggle on the LCTHM
switch on the LDD driver.
V+
D+
D-
GND
Table 1 Wiring to Cat5 cables

Mounting

The Colour Touch VW Controller is housed in a standard Clipsal plate, and as such is compatible with any
standard mounting boxes or clips. There is also a mounting frame (Clipsal Part number 4000VH1) available
in 5 colours that can be used to cover the black base and compliment wall colour.
To install the Colour Touch VW Controller
1.
Remove the fascia by inserting a small flat blade screwdriver into the slots on the top and bottom
of the plate and lever it off.
2.
Mount to wall using appropriate hardware.
3.
Re-attach fascia by pushing it into place at the top then at the bottom.
digilin.com.au
+617 3899 1267
T 5 6 8 A
Blue
Green/White
Green
Blue/White, Brown,
Blue/White, Brown,
Brown/White
T 5 6 8 B
Blue
Orange/White
Orange
Figure 1 Connections on the Colour Touch Controller
Brown/White
Page 5 of 11