Accurite 06053 Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengulang Accurite 06053. Accurite 06053 8 halaman. Wireless signal repeater

Search for Available Sensors

Once the repeater is powered on (switches turned to ON in the battery

compartment), it will begin searching for sensors transmitting the corresponding

ID for 5-10 minutes. If you wish to connect a sensor after the initial 5-10 minute

search, press and release the "Search" button in the battery compartment to

manually search for sensors within range.

Connecting one sensor

1. Relocate the sensor near the repeater and take note of the A-B-C channel.

All compatible sensors have an A-B-C channel, except monitors (models

00275 and 00276) which use channel ID "P" on the repeater.

2. Turn ON the corresponding channel ID switch for this sensor in the battery

compartment of the repeater.

3. Wait for the channel's LED indicator to flash, confirming that the sensor is

connected and is transmitting the sensor's signal.

Connecting multiple sensors

1. Of your available sensors, determine which ones need their wireless signal

repeated. Relocate those sensors near the repeater. Take note of the A-B-C

channels. All compatible sensors have an A-B-C channel, except monitors

(models 00275 and 00276) which use channel ID "P" on the repeater.

2. Turn ON the corresponding channel ID switches for these sensors in the

battery compartment of the repeater.

3. Wait for the LED indicator to flash* for each active repeater, confirming that

the sensors are connected and are transmitting the sensor's signal.

*If the repeater has connected to more than one sensor with the same channel

ID, the LED indicates how many sensors with that channel ID are being

repeated:

• One flash: Indicates that one sensor was repeated.

• Two flashes: Indicates that the second of two sensors was repeated.

• Three flashes: Indicates that the third of three sensors was repeated.

NOTE: You may connect up to 3 sensors per channel ID, however for best

results, use separate A-B-C channel IDs for sensors that include this setting.

Refer to the corresponding sensor manual for instructions on setting the A-B-C

channel.