FIAMA F18-K Panduan Pengguna dan Pemeliharaan - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengguna dan Pemeliharaan untuk Monitor FIAMA F18-K. FIAMA F18-K 8 halaman. Display for magnetic band with internal battery power supply
Halaman Cetak
Display for magnetic band
Sensor mounting
The sensor has be mounted according to the following draw, and keeping the indicated tolerances.
For the optimal system functioning its is necessary that the distance between the sensor and the magnetic
band is not over 1mm of the useful stroke.
MAGNETIC BAND
(
PLASTIC FERRITE SIDE TOWARD THE
SENSOR
N.B. if the distance between the sensor and the magnetic band is over 1mm on the display appears
,and the measured value is wrong.
Programming
To step into the parameter programming press key
times key
and appear 4 zeroes, the first on the right is blinking, with keys
RESET
(digit selection), set out password 0273 and confirm with
out of the programming. The parameters that have to be set can be run with key
appearance they are:
To enter into the modification of the selected parameter press two times
value) and with keys
To go out of the programming press
Value to be displayed for 100 mm of sensor displacement
This parameter together with the following allows the programming of the value on the display for a certain
displacement of the sensor. It means that is necessary to set the value which has to be displayed
corresponding to a displacement of the sensor on the magnetic band of 100mm.
The Factory value is
VISUAL
decimal resolution.
The range allowed is from 0,00001 to 999999 with setting of decimal point position that is, after programming
of the last digit on the left, pressing key
the wanted position. Confirm with
Number of decimal digits
It is the number of decimal digits to visualize on the display, range allowed from 0 to 5.
Example 1: for each 100 mm of sensor displacement will have a displacement on the machine of 50, set
=
50 and
Example 2: for each 100 mm of sensor displacement on display has to appear 12,3. Set
= 000012,3 e
Date: 13/01/16
)
value to be displayed for 100mm of sensor displacement,
number of decimal digits,
count direction,
keys opening mode
displacement of origin,
not used.
and
set the wanted value to be confirmed with
.
=100.0, which is the necessary value to read the displacement in millimeters with
will blink the decimal pinpoint and with key
.
RESET
=
0.
= 1.
±3°
±3°
and on the display appears
. In case of wrong set-out of password it goes
RESET
File: F18_K ing.doc
F18-K
, now press 2
(digit increase) and
and in order of
(one time displays only the
RESET
.
RESET
it can be moved to
±3°
4/8