Digilock Next Lock Range Vertical Panduan Produk - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Produk untuk Dengan kunci Digilock Next Lock Range Vertical. Digilock Next Lock Range Vertical 5 halaman.
Halaman Cetak
Support
Sleep Mode
After three consecutive incorrect User Code entries to unlock, the lock will go into Sleep Mode for one minute. For each subsequent incorrect
entry, the lock will remain in Sleep Mode for an additional minute. The keypad is disabled while in Sleep Mode. A valid Manager Flex Key may
be used to unlock while the lock is in Sleep Mode.
Error Condition Indicators
10 rapid beeps:
The lock is binding, meaning either door alignment or items in the locker are preventing the lock from operating. Press on the door while
operating the lock. If error condition persists, contact Digilock support for assistance.
2 sets of three beeps:
The batteries are low. Replace the batteries.
Does not Unlock with the User Code or User Key
The lock does not recognize the User Code or User Key. For immediate access, operate with a valid Manager Flex Key.
Does not Operate with a Manager Flex Key
The lock does not recognize the Manager Flex Key. Contact Digilock Support. For immediate access, operate with another valid Manager Flex
Key.
No Audible Feedback when = is Pressed
▪
The lock may be in Sleep Mode or the batteries may need to be replaced. For immediate access, operate with a valid Manager Flex Key.
▪
The front unit may not be properly connected to the rear unit. Remove the lock from the door and check the connection.
Battery Replacement
It is not necessary to remove the lock from the door. In case of battery failure, operate with a valid Manager Key.
CAUTION: Risk of explosion or leakage if battery is replaced by an incorrect type, mixed with a different battery type, or inserted backwards.
Replace all batteries of a set at the same time. Be sure to insert batteries with correct polarities. Remove exhausted batteries from product
promptly and dispose of used batteries according to the battery manufacturer's instructions.
1
Remove the screw from the Cover Plate
with a Phillips head screwdriver.
Remove the Cover Plate by lifting the tab at
the edge of the cover, below the arrows.
041719
PG-NLRK-E-DEN
5
Product Guide
Flex Key Managed - E Function
2
Remove the batteries from the housing.
Replace with four premium alkaline AA
batteries. Dispose or recycle used batteries
according to local regulations.
Keypad Interface
Shared Use Functionality
3
Replace the Cover Plate and secure with
the screw.
www.digilock.com | [email protected]
Phone: 707 766 6000