Digilock Curve RFID Basic Instal Manual - Halaman 4

Jelajahi secara online atau unduh pdf Instal Manual untuk Sistem Rfid Digilock Curve RFID Basic. Digilock Curve RFID Basic 13 halaman. Deadlatch/deadbolt motorized rear

Halaman Cetak

STRIKE INSTALLATION STEPS

Shown below Angled Strike Plate
1
Position the strike plate on the door frame aligning it with the
center of the lock's mounting holes.
3
Drill 0.25" [6.35 mm] pilot holes using a ¹/ 6 " drill bit.
5
Adjust the strike plate to the proper position 0.32" [8 mm]
from the door edge then tighten the self tapping screws.
4
I NSTALL GU ID E
Keypad & RFID | Basic & Advanced
2 i n
0 . 3
m ]
[ 8 m
Mark Here
Drill Pilot
Holes Here
2 i n
0 . 3
m )
( 8 m
2
2 i n
0 . 3
[ 8 m
Allow 0.32" [8 mm] from door edge and mark the position of
the adjustment slot holes.
4
Position the strike plate and the self tapping screws into the
adjustment slot holes. Do not tighten the screws.
6
Insert and tighten the remaining self tapping screw into the
center opening to secure strike position.
m ]
Mark Here