Fiamm FLX Panduan Petunjuk Pemasangan & Pengoperasian - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan & Pengoperasian untuk Aksesori Kamera Fiamm FLX. Fiamm FLX 14 halaman. Industrial batteries agm valve regulated lead acid batteries
FIAMM Industrial Batteries
FIAMM AGM Valve Regulated Recombination Batteries: FLX Series- Engineering Manual
6 SAFETY
Under normal operating conditions FLX Series batteries are considered 'office compatible'. However,
under abusive conditions, such as charger malfunction or physical damage, there is potential danger of
corrosion or fire. Therefore it is strongly recommended to carefully read the instructions contained in this
manual to avoid any critical situation. In any case local safety regulations for electrical equipment sites
must be regarded as a basic requirement.
Protective material list
Make sure that the following equipment is available to personnel working with batteries:
-Engineering/installation manual;
-Insulated spanners and tools;
-Fire extinguishers;
-Proper protective clothing.
Safety Precautions
Batteries are no more dangerous than any other electrical equipment when handled properly.
So for safety reasons it is necessary to follow few important precautions below reported:
-Do not allow metal objects to rest on the battery or fall across the terminal posts;
-Never wear rings or metal wristbands when working on batteries;
-Do not try to remove the battery cap to add water or acid into the cell(s);
-Do not touch non-insulated terminals or connectors as there is a risk of electric shock;
-Do not allow naked flames, hot objects or sparks near the battery;
-Do not smoke near the battery or in the battery room.
The electrolyte (diluted sulphuric acid) is extremely corrosive. Any contact with eyes can cause severe
and permanent damage. Contact with skin could result in severe burns. In case of severe physical
contact with electrolyte wash the affected area with running water immediately and go to the closest
hospital to seek medical attention.
Decommissioning of the batteries
Most components of a lead acid battery are recyclable. Lead acid batteries must be disposed according
to local regulations. It is strongly recommended that, at the end of their service life, batteries are
delivered to a certified lead smelter for proper recycling.
7 APPLICABLE STANDARDS
FIAMM FLX batteries comply with International Standards. Furthermore, FIAMM valve regulated
recombinant batteries are approved by most major Telecom Operators, UPS and Power Equipment
manufacturers.
8 RECORDS DATA
Complete written records of the installation, maintenance and testing of the product is important to
ensure a proper understanding of the operational history of the batteries.
Records are necessary for the manufacturer/user to understand when corrective actions should be
taken. Data required for a proper engineering review are
Production date of batteries,
•
Installation date,
•
Historical average temperature of the site,
•
Float voltage,
•
Discharge frequency,
•
Load applied during each discharge.
•
This document and any confidential information it contains shall be distributed, routed or made available solely with written permission of
FIAMM. FIAMM reserves the right to change or revise without notice any information or detail given in this manual
December 2012
10
Page