Crescend C5 Series Manual - Halaman 12

Jelajahi secara online atau unduh pdf Manual untuk Penguat Crescend C5 Series. Crescend C5 Series 17 halaman. Continuous duty power amplifier

3.3.

INITIAL STARTUP

To perform the initial start-up, proceed as follows:

Check to ensure that all input and output cables are properly connected and tightened.

Note: Use high quality coaxial cable and connectors. Properly install and solder all

connectors for reliability.

CAUTION:

Before applying power, make sure that the input and output of the

amplifier are properly terminated in 50 ohms. Do not operate the

amplifier without a load attached. Refer to Table 1-2 for input

power requirements. Excessive input power will damage the

amplifier.

NOTE:

The output coaxial cable between the amplifier and the antenna

must be 50 ohm coaxial cable.

2. Apply DC power to the amplifier. Verify that the power supply measures 13.8 ± 0.1VDC.

The fan will come on immediately for a few seconds and then turn off.

3. Visually check the indicators on each amplifier module, and verify the following:

The DC PWR ON indicator (green) should be on.

All ALARM LED indicators (red) should be off.

4. Turn on external exciter/transceiver and apply RF input signal. The fan should turn on

after approximately 3 seconds.

5. Turn off RF input signal. The fan should continue running, but turn off after

approximately 6-8 seconds.

040003A001 Rev C