Digimax 210 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Termostat Digimax 210. Digimax 210 12 halaman. Programmable thermostat compatible with maxi controller
Juga untuk Digimax 210: Panduan Pengguna (11 halaman)

Halaman Cetak

utes the Red LED will flash for 3 seconds. If the RF-Max

does not receive regular RF signals the Red LED will

come full on indicating that a fault condition has occured

and the heating system will be switched off.

Note : If more than one "Thermostat RF- RF Receiver" is

installed with the same caracteristics, it is important to apply

the above process for each thermostat, in order to be sure

that each thermostat is connected to the right receiver.

c) Trouble shooting

1. Red LED stays full on :

This may indicate that the batteries need to be replaced or

that there is an interference with another radio signal.

2. Installation :

If nothing happens after 20 continuous seconds of

pressing of the Install button of the receiver, check that the

thermostat transmits its radio signal (the symbol ]]] flashes

on the display of the thermostat)

3. Minimum temperature level :

If while adjusting the set point it is found that it cannot be

set below 16°C check with the installer that the unit has

not been configured to restrict the minimum set point (this

often required for installations in sheltered accomodation).

See 'Configuring' in the installation guide of how to re-

configure the unit.