Digimax 210 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Termostat Digimax 210. Digimax 210 11 halaman. Programmable thermostat compatible with maxi controller
Juga untuk Digimax 210: Panduan Pengguna (12 halaman)

Halaman Cetak

- thermostat on zone 2 will generate message on code B2,

- thermostat on zone 3 will generate message on code B3,

- thermostat on zone 4 will generate message on code B4.

If the console is on Housecode B,

- thermostat on zone 1 will generate message on code C1,

thermostat on zone 2 message on code C2 etc...

c) programming of the setback temperature

1. Set the security console mode switch to the INSTALL po-

sition.

2. Key in your PIN code (factory default 0000).

3. Press key number 9

4. Press ENTER

5. Key in the setback temperature between 1 to 9 in degree

Celcius.

6. Press ENTER.

7. Reset the mode switch to Run1 or Run2

d) Telephone

When theMaxi Controller is "Arm Away", it is possible using

its dial-in function features, to apply or not the setback differ-

ential to the "comfort" setpoint:

To apply the temperature set back

1. Call the security console from a touch tone or mobile

phone.

2. The console will answer your call with 3 short beeps.

3. After these beeps, enter your PIN code via the phone (fac-

tory default 0000).

4. The console confirms a correct PIN code with 3 short

beeps (an erratic PIN code is indicated by one long beep).

Page 9