Crescent SC351 Panduan Pengguna dan Pemeliharaan - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna dan Pemeliharaan untuk Scrubber Crescent SC351. Crescent SC351 2 halaman.
Juga untuk Crescent SC351: Panduan Pemecahan Masalah (2 halaman)

Halaman Cetak

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual

1. Disconnect the battery charger cable

from the electrical main.

6. Press the enabling push-button to -

gether with the brush levers to en -

gage the brush/pad-holder and then

release it.

11. Wash with clean water the recovery

tank.

16. Clean the machine using a damp

cloth and where needed use a neu

tral cleaning product.

If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this this

procedure may cause damage to the batteries. Charging the batteries after every use is recommended.

PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS

2. Fill the tank with a solution suitable

for the work to be performed.

7 . Press the solution ﬂow control

switches as necessary, depending

on the type of cleaning to be

performed.

12. Wash with clean water the vacuum

grid.

17. Charge the batteries: Connect the

battery charger cable from the elec -

trical main.

3. Always follow the dilution instruc-

tions on the label of the chemical

product used to prepare the

solution. The solution temperature

must not exceed 40°C and be none

foaming

8. Press the enabling push-button to -

gether with the brush levers for start -

ing ﬂoor cleaning. If solution applied

ﬂows outside the brush housing dur

ing use, reduce the ﬂow of solution.

13. Remove the brushes and clean

them.

18. Park the machine with the recovery

tank cover open.

4. Place the brushes or the pad-holders

under the deck. Use the appropriate

brushes to clean the ﬂoor.

9. Turn the knob to "0" position to

switch off the machine.

14. Take the squeegee off and remove

debris.

www.crescentindustrial.co.uk

SC351

5. Turn the knob on one of the

indicated programs

10. At the end of the work. Empty the

recovery. Then empty the solution

tank.

15. Check and clean the squeegee

blades.