Digimerge DND7220 Series Panduan Instalasi Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi Cepat untuk Kamera Keamanan Digimerge DND7220 Series. Digimerge DND7220 Series 20 halaman. High resolution dual-codec vandal resistant day/night dome network camera

Halaman Cetak

Continued

Hardware Installation - Adjusting the Lens

NOTE: The lens should be adjusted prior to

reattaching the camera cover. If you are adjust-

ing the Camera using a direct connection to a

PC, you will need to use a Crossover Ethernet

Cable, or use the BNC Analog Output.

1. Adjust the Angle, Zoom and Focus

controls:

i. Loosen the two screws on the side of the

Lens. Adjust the Angle of the Lens

assembly, and tighten the screws to hold

the assembly in the desired position.

ii. Use a screwdriver to loosen the Zoom screw.

Move the adjusting screw left and right to

turn the Zoom Ring. Once the lens is set to

the desired Zoom, tighten the screw to hold

the lens placement.

iii. Use a screwdriver to loosen the Focus

screw. Move the adjusting screw left and

right to turn the Focus Ring. Once the lens

is set to the desired Focus, tighten the

screw to hold the lens placement.

iv. Replace the Cover on the Camera Base

and attach with the 4 securing screws with

the Security Hex tool.

HARDWARE CONNECTIONS

SCREW 1

1ii

ZOOM

RING

1iii

FOCUS

SCREW

DND70 Series_Quick Installation Guide_En_R1

SCREW 2

w w w

d i g i m e r g e

c o m

Page