Digimerge DPD24D Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kamera Keamanan Digimerge DPD24D. Digimerge DPD24D 15 halaman. Ultra resolution day & night dome camera
Juga untuk Digimerge DPD24D: Buku Petunjuk (15 halaman), Buku Petunjuk (14 halaman)

Halaman Cetak

INSTALLATION. VANDAL DOME

ATTENTION - If using DC power, follow the correct

polarity as marked on the power cable.

1) Loosen the three tamper screws using the provided

allen key. Lift the dome cover.

Note: If you plan to use conduit fitting, remove conduit

Method 1 - Direct Attach Install

2a) Use the included mounting template (Installation

Option 2) to mark and pre-drill the required holes.

Remove 2 of the 3 base locking screws. Use 2pc of

the 2.8" screws to mount the camera directly to the

mounting surface.

Remove the 3rd base locking screw and install the 3rd

2.8" screw.

Go to step

Method 2 - Camera Base Install

2b) Use the included mounting template (Installation

Option 1) to mark and pre-drill the required holes.

Remove the camera base by unscrewing the 3

base locking screws, and turn camera module

approx. 5 degrees counter-clockwise to detach

camera base from the camera module. Install the

base to the correct holes as indicated on the mount

template using the 1.2" screws. Go to step 3a.

Method 3 - Junction Box Install

2c)

(see page 4 for details). Remove the camera

base by unscrewing the 3 base locking screws,

and turn the camera module approx. 5 degrees

counterclockwise to detach camera base from

camera module. Install the base to the junction box

using the base attachment screws. Go to step 3a.

3a) Reinsert camera module into camera base by

aligning the arrow notches on the edge of the

camera module and the camera base (label on

edge of camera module indicates the location

of the arrow notch), and turning camera module

clockwise to lock into place.

3b) Use the 3 base locking screws to secure

camera base to camera module.

Go to step

-6-

cap using the provided conduit key.

stallation Option 1:

Use holes marked with 'A' when

installing camera base first.

Use short 30mm screws and anchors.

Installation Option 2:

Use holes marked with 'B' when

installing complete camera housing.

Use long 70mm screws and anchors.

Mounting Template

Conduit Key

Allen Key

on page 7 to complete installation.

INSTALLATION. VANDAL DOME

4) Remove camera cover by squeezing the back and front

of the cover (as indicated by the arrow indicators) at the

same time and lifting it up and away from the lens.

Arrow

5) Insert the included video test cable into the RCA jack and

connect to a test monitor to set up camera.

Video test cable

RCA Jack

Zoom

Focus

6a) Adjust camera viewing angle and secure into

screwdriver.

Note: Lens adjustment levers are by default in the

locked position. Turn counter clockwise to unlock.

Tighten levers to secure lens setting.

6b) Adjust lens and OSD as required.

6c) Re-attach the camera cover, using the thumb screw

as a guide, until it snaps into place.

7a) Re-attach the dome cover. Align arrows according to the

diagram below to ensure a weatherproof seal.

Correct arrow alignment

7b) Use the allen key to tighten the tamper screws.

Note: Make sure dome cover cord does not get caught in

the rubber seal.

Thumb Screw

Arrow on camera base

Arrow on camera module (inside camera)

Arrow on dome cover.

-7-