Accusplit Alliance 1520 Petunjuk Pengoperasian

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Pedometer Accusplit Alliance 1520. Accusplit Alliance 1520 1 halaman. Accusplit activity pedometer operating instructions

Halaman Cetak

ACCUSPLIT®

ALLIANCE

ACTIVITY PEDOMETER

OPERATING INSTRUCTIONS

Congratulations on taking the ﬁrst step to wellness

with your purchase of an ACCUSPLIT pedometer.

It's easy to set up your new pedometer.

Just follow the steps below, and start walking!

WEARING YOUR PEDOMETER

While gently holding the belt clip open, slide the pedometer onto

your belt or the top edge of your pants or skirt. It should ﬁt snugly

and level, above one knee.

Note: The pedometer should be as vertical as possible. Walkers

with larger stomachs may ﬁnd it helpful to wear the pedometer

farther back on the body, toward one hip.

The cover must be closed for the pedometer to work. To avoid

losing or dropping your pedometer, use the included leash and clip

to fasten the pedometer securely to your clothing.

Opening your pedometer: You must open

the pedometer to see your results. The unit is

most easily opened while you are wearing it.

To open unit while wearing, place your thumb

on the tab at top. Use your thumb to pull

Attaching the Leash: Attach the pedometer to the leash by looping

the leash around the pedometer belt clip. Next, clasp the waistband

of your clothing with the Attached clip. You can also use a safety pin

to fasten the leash to your clothing, loop the leash through your belt

or belt loop or use a badge holder.

VIEWING YOUR RESULTS

Once you put on your pedometer with the cover closed, it will

automatically begin to record your steps.

First, loop the

pedometer clip

Next, loop the metal clip,

then clasp clothing

Or, loop a belt or

belt loop

ACCUSPLIT, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551 USA

800-935-1996 • 925-290-1900 • FAX 925-290-1930 • www.ACCUSPLIT.com • [email protected]

1520

the cover up and away from

your body. If not wearing the

pedometer, turn the unit so that

the back side is facing you (see

images at left). Grasp the belt

clip with one hand, and then

open as described above.

Or, loop a

badge holder,

then put into pocket

(Badge holder not included)

DISPLAY MODES

• STEP

Counts steps taken since last RESET.

Reset daily to count each day's steps.

00508

ACCUSPLIT

AccuSTEP 10000 ORG RESET

RESETTING YOUR PEDOMETER

Most people prefer to reset step counts daily. To reset: Press

and hold yellow RESET button for at least two seconds to

reset to zero.

AUTO MOVEMENT SENSOR

1. To ﬁlter out random movements, the unit remains in

standby mode until 5 continuous steps are registered.

Only then are the 5 steps calculated in, and an Active

indicator "▲" appears on the upper left of display.

2. When regular walk/run movement stops, after 2 seconds

the timer pauses and the unit switches to standby status

(Active indicator "▲" disappears).

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to

replace the battery. Your pedometer uses one Type LR44

1.5 volt alkaline battery. To replace:

1. Insert a coin into the slot on the bottom of the case, and

twist counterclockwise to loosen the case front. Lift case

front away.

2. Using a pen or other thin object, push battery sideways

out of its holder. Replace it with a new battery. The

battery's positive (+) terminal should be FACE UP while

you put it into the pedometer.

3. Align case front over the pedometer and press gently to

snap cover back into place, starting with top.

Please return

Email (preferred)

your AL1520 Registration to the

User

Repair Center address in the

warranty, and we will let you

know about future products.

NO-PROOF-OF-PURCHASE LIMITED WARRANTY

See label inside the lid of the pedometer.

STEP

ACTIVITY

PEDOMETER

1520

ALLIANCE

RESET button

960-044