Accusplit EAGLE 1120 Petunjuk Pengoperasian

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Pedometer Accusplit EAGLE 1120. Accusplit EAGLE 1120 1 halaman.

Halaman Cetak

Congratulations on taking the first step to wellness with your purchase of an

WEARING YOUR PEDOMETER

While gently holding the belt clip open, slide the pedometer

onto your belt or the top edge of your pants or skirt. It should fit

snugly and level, above one knee.

Note: The pedometer should be as vertical as possible. Walkers

with larger stomachs may find it helpful to wear the pedometer

farther back on the body, toward one hip.

To avoid losing or dropping your pedometer, use the included

leash and clip to fasten the pedometer securely to your clothing.

Attaching the Leash: Attach the pedometer to the leash by

looping the leash around the pedometer belt clip. Next, clasp

the waist-band of your clothing with the attached clip. You can

also use a safety pin to fasten the leash to your clothing, loop

the leash through your belt or belt loop or use a badge holder.

First, loop the

pedometer clip

Next, loop the metal

clip, then clasp clothing

Or, loop a belt or belt loop

VIEWING YOUR RESULTS

Once you put on your pedometer, it will automatically begin to

record your steps.

NO-PROOF-OF-PURCHASE LIMITED WARRANTY

Refurbish, repair-or-replace service before 10/1/10, $5 fee; After 10/1/10,

service may not be available. Return with fee and day phone # to:

AST Repair Center/970-1010, 2290M Ringwood Ave., San Jose, CA 95131

ACCUSPLIT, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551

925-290-1900 • 800-935-1996 • FAX 925-290-1930 • www.ACCUSPLIT.com • [email protected]

ACCUSPLIT®

EAGLE

OPERATING INSTRUCTIONS

ACCUSPLIT pedometer. It's easy to set up your new pedometer.

Just follow the steps below, and start walking!

Or, loop a

badge holder, then

put into pocket

(Badge holder

not included)

Eat Right! Walk More! Live Well! The ACCUSPLIT Lifestyle

1120

™

AccuSTEP

TW15MG

ACCUSPLIT

EAGLE

RESETTING YOUR PEDOMETER

Most people prefer to reset step counts daily. To reset:

Press and hold RESET button for at least three seconds to

reset to zero.

AUTO MOVEMENT SENSOR

1. To filter out random movements, the unit remains in standby

mode until 5 continuous steps are registered. Only then are

the 5 steps calculated in, and an Active indicator "▲"

appears on the upper left of display.

2. When regular walk/run movement stops, after 2 seconds the

timer pauses and the unit switches to standby status (Active

indicator "▲" disappears).

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to

replace the battery. Your pedometer uses one Type L1142

(LR43) 1.5 volt battery. To replace:

1. Using a jeweler's screwdriver, loosen small screw

on back of unit. Remove back of case.

2. Slide the old battery gently out of its holder. Replace it with

a new battery. The battery's positive (+) terminal should be

FACE UP while you put it into the pedometer.

3. Gently press front and back of pedometer case back

together, being sure to line up slots and tabs at top and

bottom of unit.

4. Replace the screw snugly, but gently.

5. Perform a RESET function, pressing RESET button for

3 seconds.

Please return

your AE1120 Registration to the

Repair Center address in the

warranty, and we will let you

know about future products.

10000.org

STEP

1 1 2 0

RESET

Email (preferred)

User

970-042vB